No Power. Problem with control panel. Power button no longer works. Unbalances very easy. Unfortunately no longer under warranty so you just have to pay your local serviceman $140 call out fee to repair. Do not recommend Simpson washing machines....

Had a simpson for 10 years. After having my daughter I needed a bigger one. Purchased new one in 2013, have had the guy out to fix it 3 times (extremely rude) problem was with unbalancing - he said I can NOT use ECO setting as it is only there to help...

balance on this machine has been hopeless since day one ,now the final insult , no power at all , power points are fine ,also rusting on the outside, i guess this is because on the rinse cycle it just sprays water from top to bottom wetting the lid and...

Had nothing but trouble with the machine throwing itself off balance every wash. In the beginning it would only happen every now and then but now I have to stand next to the machine while it washes. It is not balanced, doesn't matter how I distribute...

I had my last Simpson washing machine for around 15 years and then it was time for a new one. So obviously I bought another Simpson just over 2 and a half years ago. I do find it a little noisy (my other one was quieter) but I am happy with it. My main...

i have the owned simpsons for over 40 years - this one is a shocker always unbalanced loads - it did my head in last night and i got so upset i ended up in hospital - dam thing - guess where its going when i get out !!! and i will be thinking very hard...

No other part has ever been a problem in these approx 7 years. Easy to clean inside and out. Washes well. Could be a little shorter cycle. Does not harm the different materials and soft fabrics. I always keep bras and special clothing in slip covers so...

Positives. Washes clothes OK. Lint filtering works well. Negatives. Severe unbalance problems worsening since new. Requires manual intervention to reposition load nearly every spin cycle. Even when load is manually redistributed, the tub action dumps...

spacer/washer that I fashioned by drilling a hole in a piece of 4mm thick nylon cut almost the same diameter as the retainer. The spacer was placed on the rod and the retainer replaced with the short shaft of the retainer passing through the spacer,...

spin cycle out of balance all the time to the point outside casing of machine has been dinted, Does anyone have a solution how to tighten or resolve. The associated noise is overbearing. Also the entire time of full cycle far to long.